Publicidad
Idiomas disponibles
Idiomas disponibles
• The robot will retract mop mount when cleaning the
carpet. You can also set the carpet as a no-go zone in
the app to avoid it.
• Before starting each mopping task, make sure that the
VibraRise mop has been properly installed.
Spot Cleaning
Press the
button to start spot cleaning.
Cleaning range: The robot cleans a 1.5 m
(4.9 ft) x 1.5 m (4.9 ft) square area centered
on itself.
Note:
After spot cleaning, the robot will automatically
return to the starting point and enter Standby mode.
Pause
When the robot is running, press any
button to pause it, press the
resume cleaning, press the
send it back to the dock.
Note:
Placing a paused robot on the dock manually will
end the current cleanup.
Sleep
If the robot is paused for over 10 minutes, it
will go to sleep, and the power indicator will
flash every few seconds. Press any button to
wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left in sleep
mode for more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND is on, the robot will not
automatically resume cleanup, the power
indicator light will dim, and the volume of
the voice prompts will lower.
Child Lock
Press and hold the
disable the child lock. You can also set it in
the app. Once enabled, the robot will not
react to button presses when it is stationary.
When the robot is cleaning or docking,
button to
press any button to stop it.
button to
Charging
After cleaning, the robot will automatically
return to the dock to charge and will determine
if mop washing, drying and emptying are
needed upon returning to the dock according
to its past cleaning behavior.
In Pause mode, press the
the robot back to the dock. The power
indicator will pulse as the robot charges.
Note:
If the robot fails to find the dock, it will
automatically return to its starting location. Place the
robot on the dock manually to recharge.
System Reset
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system. Press the Reset button,
and the robot will reset automatically.
Note:
WiFi, etc. will be restored to factory settings.
Restoring Factory Settings
If the robot does not function properly
after a system reset, switch it on. Press and
button to enable/
hold the
press the Reset button until you hear the
"Restoring factory settings" voice prompt.
The robot will then be restored to factory
settings.
Mop Washing
During cleaning, the robot automatically
determines when it should return to
the dock for mop washing and water
tank refilling to maximize its mopping
performance. To manually start washing,
tap Wash button in the app or press and
button to send
hold the
back. Press any button to stop washing.
Notes:
• To allow the robot to wash the mop automatically,
• Mop washing duration is 20 minutes by default and you
09
After resetting the system, scheduled cleaning,
button and at the same time,
button on the robot to send it
start the robot from the dock and do not move the
dock during cleaning.
can modify this duration or washing mode in the app.
Publicidad
