Publicidad
Idiomas disponibles
Idiomas disponibles
Emptying
Auto-emptying will automatically begin when
the robot returns to the dock after cleaning.
To manually start emptying, press
on the docked robot or tap Empty button in
the app. Press any button to stop emptying.
Notes:
• When auto-emptying has been left unused for a long
period, empty the dustbin manually and make sure
the air inlet is clear for optimal emptying performance.
• Auto emptying can be disabled through the app.
• Avoid frequent manual emptying.
Drying
Drying starts automatically after mop
washing or after cleaning are completed.
To manually start or stopping drying, tap
Drying button in the app.
Notes:
• Drying duration is 2 hours by default and you can
modify this in the app.
• Auto drying can be disabled through the app.
Routine Maintenance
D
Main Brush
D1
button
* Clean every 2 weeks and replace every 6-12 months.
D1-1—Main Brush Cover
D1-2—Latches
D1-3—Main Brush
D1-4—Main Brush Caps
D1-5—Main Brush Bearing
D1-6—Turn over the robot and press the
latches to remove the main brush cover.
D1-7—Pull out the main brush and remove
the main brush bearing.
D1-8—Remove the main brush cap, rotating
in the unlock direction. After cleaning,
reattach it turning in the lock direction.
D1-9—After removing the tangled hair or
dirt at both ends of the main brush,
reinstall it, press on the main brush
cover to lock it in place.
Notes:
• Main brush should be wiped down with wet cloth and
left to dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brush.
Side Brush
D2
* Clean monthly and replace every 3-6 months.
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the screw.
D3
* Clean as required.
D3-1—Use a tool, such as a small screwdriver,
Note:
removed.
D3-2—Rinse the wheel and the axle with
D4
* Clean monthly.
Clean the main wheel with a soft, dry cloth.
D5
* Clean as required.
D5-1—Open the top cover of the robot and
D5-2—Press the cover latch to open the
D5-3—Fill the dustbin with clean water and
Note:
any cleaning liquid.
10
Omnidirectional Wheel
to pry out the axle and take out the
wheel.
The omnidirectional wheel bracket cannot be
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
Main Wheel
Dustbin
press the dustbin latch to take out
the dustbin.
dustbin cover and remove the washable
filter, then empty the dustbin.
close the cover. Gently shake the
dustbin, and then pour out the dirty
water. Leave the dustbin and the
washable filter to dry.
To prevent blockage, only use clean water without
Publicidad
