YASKAWA LA500 Manual De Instrucciones página 23

User Parameter
A2-15
A2-16
A2-17
A2-18
A2-19
A2-20
A2-21
A2-22
A2-23
A2-24
A2-25
A2-26
A2-27
A2-28
A2-29
A2-30
A2-31
A2-32
A2-33
◆
Drive Parameters
Refer to the following table when you set the most important parameters.
Note:
You can change parameters that have "RUN" in the "No." column during drive operation.
No.
(Hex.)
A1-02 Control Method
Selection
A1-03 Initialize Parameters
b1-02 Run Command
Selection 1
b1-03 Stopping Method
Selection
YASKAWA TOMPYEULA5001C LA500 Installation and Operation Instructions
Parameter
d1-07
d1-08
d1-28
d1-29
C1-01
C1-02
C2-01
C2-02
C2-03
C2-04
C2-05
E2-03
S1-02
S1-03
S1-06
S1-07
Name
Sets the control method for the drive application and the motor.
0: V/f Control, 2: Open Loop Vector
Sets parameters to default values.
0: No Initialization, 1110: User Initialization, 2220: 2-Wire Initialization
Sets the input method for the Run command.
0: Keypad, 1: Digital Input
Sets the method to stop the motor after removing a Run command or entering a
Stop command.
0: Ramp to Stop, 1: Coast to Stop
Name
Speed Reference 7
Speed Reference 8
Nominal/Leveling Spd Detection
Inspection Speed Detection
Acceleration Time 1
Deceleration Time 1
S-Curve @ Start of Acceleration
S-Curve @ End of Acceleration
S-Curve @ Start of Deceleration
S-Curve @ End of Deceleration
Jerk @ Levelig
Motor No-Load Current
DC-Injection @ Start
DC-Injection @ Stop
Brake Open Delay
Brake Close Delay
User Parameter Selection
Description
1 English
23