Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THE CLOCK
SETTING THE SLEEP TIMER
1,3,5
2,4
CLOCK
When the AC cord is connected for the first time, the clock on
the display flashes.
Set the time as follows while the power is off.
1
2
3
4
5
Press the SET button.
The hour flashes.
Press the DOWNY
or
UPA
button to designate
the hour.
Press the
SET
button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the DOWNV
or UPA button to designate
the minute.
Press the SET button to set the minute.
The minute stops flashing on the display and the clock starts
from 00 second.
To correct
the current
time
Press the POWER button to turn the unit off. Press the SET
button and carry out steps 1 to 5 above.
To display
the current
time
Press the CLOCK button on the remote control. The clock is
displayed for 4 seconds.
To switch to the 24-hour standard
Press the POWER button while pressing the
UPA
or DOWNY
button while the current time is displayed.
Repeat the same procedure to restore the 12-hour standard.
If the clock display
flashes
while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase need to be reset.
f~
G
--+
0000
000
000
—2
1
00
Ja)oo=
00
.=,
3
The receiver can be automatically turned off at a specified time.
Use the remote control.
1 Press the AIWA RECEIVER button.
2 Press the SLEEP button.
3 Press the UP-
or DOWN-
button within
four
seconds
to
specify
the
time
until
the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned off
Press the SLEEP button once. The remaining time is displayed
for four seconds.
To cancel the sleep timer
Press the SLEEP button twice so that "SLEEP on the display
disappears.
15
ENGLISH
Publicidad
