Publicidad
Idiomas disponibles
Idiomas disponibles
CENTER SPEAKER IMP: 8Q14f2
selectable
With the SPEAKER IMPEDANCE
SELECTOR set to 4Q, accepts
speaker of 4 ohms.
With the SPEAKER IMPEDANCE
SELECTOR set to 8Q, accepts
speaker of 8 ohms or more.
PHONES (stereo jack): accepts
headphones of 32 ohms or more
Muting
-20 dB
General
Power requirements
120 V AC, 60 Hz
Power consumption
210 W
Dimensions
360 x 153.5x 335 mm
(W XHXD)
(141/, x 6'/0 x 131/, in.)
Weight
10.3 kg (22 lb 11
OZ.)
Specifications and external appearance are subject to change
without notice.
BBEsYsTEM
The word "BBE and the "BBE symbol" are trademarks of BBE
Sound, Inc.
Under license from BBE sound, Inc.
DOLBY PRO LOGIC
Manufactured under license from Dolby Laboratories Licensing
Corporation.
"DOLBY" the double-D symbol OU and "PRO LOGIC" are
trademarks of Dolby Laboratories Licensing Corporation.
TROUBLESHOOTING
GUIDE
If the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
There is no sound.
Is the AC cord connected properly?
Is there an incorrect connection? (+ page 3)
There may be a short circuit in the speaker terminals.
~ Disconnect
the AC cord, then correct the speaker
connections.
Was an incorrect function button pressed?
Are the FRONT SPEAKERS A and B buttons set correctly?
(- page 6)
Sound is emitted from one speaker only.
Is the BALANCE control set appropriately?
Is the other speaker disconnected?
Sound is heard at a very low volume.
c Has the MUTING button been pressed?
An erroneous display or a malfunction occurs.
+ Reset the unit as stated below.
TUNER SECTION
There is constant, wave-like static.
Is the antenna connected properly? (+ page 5)
Is the FM signal weak?
+ Connect an outdoor antenna.
The reception contains noise interference
or the sound is
distorted.
Is the system picking up external noise or multipath distortion?
-
Change the orientation of the antenna.
+ Move the unit away from other electrical appliances.
To reset
If an unusual condition in the display window or malfunction
occurs, reset the unit as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER button while pressing the SET button.
Everything stored in memory after purchase is canceled.
If the power cannot be turned off in step 1 because of a
malfunction, reset by disconnecting the AC cord and carry out
step 2.
17
ENGLISH
Publicidad
