FlexiForce FORCE70AC3-XC Manual página 7

1. POWER
When you activate the board the red LED switches on steadily for about
3 seconds.
After about 1 second, the green LED will flash a number of times equal
to the review.
When the red LED switches off, the green LED switches on steadily
indicating that the switch on procedure of the card is completed and
now it is ready for operation.
2. OPERATING LOGIC
The control unit has 2 operating logic:
1. Automatic: opening and closing are automatic.
2. Dead-man in closing: opening is automatic while closing is dead-man.
The logic of operation is selected using DIP 2 according to the following table:
OPERATING LOGIC
Automatic
Dead-man in closing / Automatic in opening
3. RADIO TRANSMITTERS' PROGRAMMING
3.1 TRANSMITTER'S PROGRAMMING THROUGH SEQUENTIAL CONTROL START/STOP (SS):
1. Place the DIP 1 in ON position. Both the red and the green LED will be switched on with a fixed light
2. Send the radio code to be memorized. The LEDs will act as follows:
GREEN LED
FAST FLASHING
OFF
FAST FLASHING
5 SLOW FLASHES
3. If further code memorization must be performed repeat step 2, otherwise place the DIP 1 in OFF.
3.2 PROGRAMMING OF THE OPEN BUTTON OF THE TRANSMITTER:
Perform the procedure "PROGRAMMING OF THE SEQUENTIAL CONTROL" by holding the
OPEN button while transmitting the radio signal.
3.3 PROGRAMMING OF THE CLOSE BUTTON OF THE TRANSMITTER:
Perform the procedure "PROGRAMMING OF THE SEQUENTIAL CONTROL" by holding the CLOSE button while
transmitting the radio signal.
3.4 PROGRAMMING OF THE STOP BUTTON OF THE TRANSMITTER:
Perform the procedure "PROGRAMMING OF THE SEQUENTIAL CONTROL" by holding the STOP button while
transmitting the radio signal.
3.5 PROGRAMMING OF THE COURTESY LIGHT WITH THE TRANSMITTER:
Perform the procedure "PROGRAMMING OF THE SEQUENTIAL CONTROL" by holding the OPEN and CLOSE buttons
while transmitting the radio signal.
RED LED
code has been memorized
OFF
code is already memorized
FAST FLASHING
memory is full
FAST FLASHING
storing refused.
Check the correct connection of the inputs
DIP 2
OFF
ON
7
RED
LED
GREEN
LED
www.flexiforce.com