UFESA AC3010 Manual De Instrucciones página 10

placed over the rubber collar in the chamber of the
vacuum cleaner.
8
Lock the plate of bag with the locking hook.
Do not vacuum when the bag is not
attached. Without the bag inside, the
front cover of the vacuum cleaner cannot
be locked.
You are recommended to replace the bag, if you notice
that:
a) the red field is covering the bag filling indicator,
b) your vacuum cleaner is vacuuming less effectively,
c) bag is full.
End of operation, cleaning and
maintenance
1
Switch the vacuum off by pressing ON/OFF
button (7).
2
Remove the plug from the power outlet.
3
Wind the cord by pressing cord rewind button (4).
While doing it, remember to hold the cord to make sure
it does not get tangled and the plug does not hit the
vacuum' s hosing.
4
Disconnect the telescopic tube and the nozzle or
the brush.
5
Disconnect the telescoping suction tube from the
hose. In order to remove the telescopic handle from
the hose handle, press latch "A" and pull the tube
towards the arrow.
6
Press the two side buttons located on the hose end
and remove the ending of the hose from the inlet opening.
7
Your vacuum cleaner may be stored in horizontal
and vertical position. The hose may stay fastened to
the vacuum cleaner, but make sure that it is not bent
too hard when stored.
Horizontal storing:
– insert the fastening hook of the suction brush into
the clip fastening the suction brush which is located
on the back side of the vacuum.
Vertical storing:
– insert the suction brush fastening hook into the clip
fastening the suction brush which is located at the
bottom of the vacuum right next to to the back wheel.
8
If necessary, the vacuum' s housing and compartment
may be wiped with a wet cloth (it may be moistened with
a detergent), dried or wiped until dry.
Do not use scouring agents or solvents.
Problems that may occur when
operating the vacuum
PROBLEM
The bag has been
damaged.
Your vacuum
cleaner is not
F
working efficiently
enough.
Power installation
fuse triggered.
Your vacuum
cleaner fails to
work, the housing
is damaged or
the power cord is
damaged.
Advice on disposal
Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
This product complies with EU Directive
2002/96/EC. The crossed wheelie bin
symbol shown on the appliance indicates that
when it comes to dispose of the product it
must not be included in with household refuse. It must
be taken to a special refuse collection point for electric
and electronic appliances or returned to the distributor
when purchasing a similar appliance. Under current
refuse disposal regulations, users who fail to take
discarded appliances to special refuse collection points
may be penalised. Correct disposal of discarded
appliances means that they can be recycled and
processed ecologically, helping the environment and
WHAT TO DO
Replace the bag and the
filters.
Replace bag and filters, check
the suction tube, hose and
nozzle – remove the reasons
for clogging.
Check whether there are other
electric appliances plugged
into the same electric circuit,
if the fuse turns on repeatedly,
take the vacuum cleaner to
the service.
Take your vacuum cleaner to
the service.