8
Switch the vacuum cleaner on by pressing ON/OFF
button (7).
9
Your vacuum cleaner comes with a power regulator
helping you to smoothly regulate its power. Power can
regulated with the slider.
10
Sliding the slider according to the marking (MAX
or MIN) will cause the suction power to increase or
decrease.
11
Your vacuum cleaner is also fitted with mechanical
suction regulator located on the hose handle. It allows
you to temporarily and slightly correct the suction
power without the need to use the slider.
Filter disassembly
Before you replace the filters, make sure that the vacuum
has been switched off and the plug is removed from
the power outlet.
INLET FILTER
1
Switch the vacuum off by pressing ON/OFF
button (7).
2
Remove the plug from the power outlet.
3
Press the two side buttons located on the hose end
and remove the ending of the hose from the inlet opening.
4
Raise the front cover interlock (8) and open the lid (6).
5
Release the hook locking the bag holder and then
remove the bag.
6
Press the inlet filter cover interlock and remove the
inlet filter cover from the vacuum cleaner.
7
Remove the inlet filter from the filter cover (13).
If the inlet filter (13) gets dirty, you can also rinse it (13)
under running water. Remember to dry the filter before
you reattach it.
For safety reasons, attaching damp or
damaged inlet filter is not acceptable.
8
Carefully attach the new/rinsed filter in the filter cover.
9
Place the filter cover back making sure that the two
splines located in the bottom part of the cover fit into
the slots on the vacuum' s hosing, press the cover in
order for the clip to lock in the hosing. The click you hear
confirms that the outlet filter cover has been correctly
attached.
Damaged outlet filter should always be
replaced with a factory new and original
item.
10
Insert the plate with the new bag into the seat of
casing in such a way that the hole in the bag plate was
placed over the rubber collar in the chamber of the
vacuum cleaner.
11
Lock the plate of bag with the locking hook.
12
Close the lid by pushing it until you hear the click –
be careful not to shut the bag.
OUTLET FILTER
1
In order to replace outlet filter (12) press the outlet
filter cover interlock and remove the outlet filter cover
from the vacuum cleaner.
2
Remove the outlet filter from the filter cover.
If the outlet filter (12) gets dirty, you can also rinse it (12)
under running water. Remember to dry the filter before
you reattach it.
For safety reasons, attaching damp or
damaged outlet filter is not acceptable.
C
3
Carefully attach the new/rinsed filter in the filter cover.
4
Place the filter cover back making sure that the two
splines located in the bottom part of the cover fit into the
slots on the vacuum' s hosing, press the cover in order for
the clip to lock in the hosing. The click you hear confirms
that the outlet filter cover has been correctly attached.
Damaged outlet filter should always be
replaced with a factory new and original
item.
Bag dismantling/fitting
1
When the bag filling indicator is completely covered
by a red screen when the nozzle or brush is raised over
the cleaned surface, it means that it is necessary replace
the bag. Bag filling indicator may also be triggered if the
suction hose or the elements connected to it are clogged.
2
Switch the vacuum off by pressing ON/OFF
button (7).
3
Remove the plug from the power outlet.
4
Press the two side buttons located on the hose end
and remove the ending of the hose from the inlet opening.
5
Raise the front cover interlock (8) and open the lid (6).
6
Release the hook locking the bag holder and then
remove the bag.
7
Insert the plate with the new bag into the seat of
casing in such a way that the hole in the bag plate was
D
E