Publicidad
Flip Front Removal and Replacement
Flip Front Removal
1.
Remove the head gear knob on both sides of the face shield.
If the face shield has Hard Hat Interchange System Slotted
hard hat adapters (HHIS), remove the hard hat slot adapter
knob on both sides of the face shield.
2.
Remove the Flip Front visor and
replace with an approved
Jackson Flip Front.
3.
Place the new Flip Front Visor on
the crown and install the head
gear knobs on both sides of the
face shield. Verify both knobs
are properly secured before
using the face shield.
Replacing the Face Shield Headgear
To replace the 370 Faceshield headgear, take the following steps:
1.
Remove the Pivot knob on both sides of the headgear.
2.
Pull the stud out of the inside of the helmet, then removing all of the Pivot Post, O-Ring
and Pivot Stop on both sides of the helmet.
3.
Right side assembly – holding the helmet in front of you, with the back facing you, insert
the threading stud through the headgear strap, Pivot Post, O-Ring and RH Pivot Stop. Then
place this sub assembly into the helmet with the angle adjustment going into the desired
hole. Thread the pivot knob on the stud that is now extending through the helmet.
4.
Repeat steps above for the left side of the helmet.
Interchange Welding Helmet System
Helmet Attachment Blades:
• 4-position tilt adjustment allows welder to center the visual field
• Tension knobs allow the welding helmet to be lowered comfortably
• Made from lightweight material that can withstand extreme temperatures of 350°F
• Vertical lock-in eliminates helmet creep securely holding in the upward position
• Approved for use with:
Jackson Slotted front brim hard hats
2
31
1
3
Publicidad
