Descargar Imprimir esta página

QSC CX Serie Manual De Instrucciones página 16

Ocultar thumbs Ver también para CX Serie:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

2- and 4-Channel Distributed 70V Line Models
Output Power (Watts)
20 - 20k Hz, 0.03% THD, 70V/Ch.
20 - 20k Hz, 0.03% THD, 8 Ohms/Ch.
20 - 20k Hz, 0.05% THD, 4 Ohms/Ch.
1k Hz, 0.05% THD (EIA), 70V/Ch.
1k Hz, 0.1% THD (EIA), 70V/Ch.
1k Hz, 1.0% THD (EIA), 70V/Ch.
Bridge Mono, 140V, 20 - 20k Hz, 0.1% THD
Bridge Mono, 140V, 1k Hz, 0.1% THD
Bridge Mono, 1k Hz, 0.1% THD, 16 Ohms
Bridge Mono, 1k Hz, 0.1% THD, 8 Ohms
Distortion, SMPTE-IM
Frequency Response
Signal To Noise, Unweighted, 20 - 20K Hz
Voltage Gain
EN
Input Sensitivity, Vrms
Output Circuit Type
Input Impedance
Dynamic Headroom
Damping Factor
Amplifier Protection
Cooling
Controls
Front
Back
Led Indicators
Connectors
Input
Output
Other
Load Protection
Power Requirements
Dimensions
Weight
Specifications are subject to change without notice.
TD-000077-00-K
CX204V
CX302V
200
200
550
700
1100
220
250
300
600
300
400
400
440
600
1200
1400
2300
<0.02%, all models
20 - 20k Hz, ±0.2dB at 10dB below rated output power, all models (-3dB points: 8 Hz and 100 kHz)
-106 dB. all models
56.6x (35dB) all models
1.26V (+4.2dBu) for rated power at 70.7V
AB
AB
6k ohms unbalanced, 12k ohms balanced, all models
2 dB at 4 Ohms, all models
>500 at 8 Ohms, all models
Short circuit, open circuit, thermal, ultrasonic and RF protection. Stable into reactive or mismatched loads
Continuously variable speed fan; back-to-front air flow through heat sink tunnel
AC POWER switch, gain controls (1 control per channel, 21 detents)
10-position DIP switch with Clip Limiter (1 per Ch.), LF Filter on/off (1 per Ch.) LF filter select: 33 or 50 Hz (1 per Ch.), Stereo/
Parallel/Bridge mode selection switches
POWER (green, 1 each), SIGNAL, -10dB, -20dB (green, 1 each per Ch.), CLIP (red, 1 each per channel), BRDG and PAR
(yellow, 1 each)
3-pin terminal blocks ("euro" or "Phoenix" type)and XLRs (pin 2 positive)
barrier strip connectors with protective shroud
QSC DataPort connector (supports full "V1"feature set)
Turn-on/turnoff muting, AC coupling (DC fault blocking), Clip limiting.
Refer to rear panel serial number label. Configured at factory for 100, 120 or 220-240 VAC, 50- 60 Hz.
19.0" (48.3 cm) W, 3.5" (8.9 cm) H, 14" (35.6 cm) D (from front mounting rails, including rear support ears)
21 pounds (9.5 kg) net; 27 pounds (12.3 kg) shipping
16
CX602V
CX1202V
400
800
440
1000
1200
800
850
1200
2400
AB
H

Publicidad

loading

Este manual también es adecuado para:

Cx302Cx502Cx702Cx902Cx1102