Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING : Danger to life due to fire or explosion : electrical devices can cause fires.
•
Do NOT install damaged modules.
•
Do NOT install modules inside.
•
Do NOT install modules on moving objects.
•
Never step on the modules.
•
•
Do NOT subject the modules to mechanical stresses.
Do NOT drop objects on modules.
•
•
Do NOT drop modules.
Never lift or move the module through the connection cables or inverter.
•
Do NOT put any things on the inverter or the modules.
•
Do NOT cover the inverter or the modules.
•
Do NOT move the installation during operation.
•
Under special circumstances, the inverter may be subject to electromagnetic interference from
•
surrounding equipment. At this time, the user is obliged to take correct measures to reduce the
interference from surrounding equipment to the inverter.
o
Never install the inverter near the sensitive equipment (e.g. Radios, telephone,
television, etc).
Do not stay closer than 20 cm to the inverter for any length of time.
o
Electrical Warnings
All electrical installations must comply with local electrical safety standards.
•
Do NOT open the casing. Do NOT attempt to repair, consult qualified service personnel. All wiring
•
and electrical installation must be performed by qualified service personnel.
Improper operation during the wiring process can cause fatal injury to operator or unrecoverable
•
damage. ONLY qualified personnel can perform the wiring work.
Touching live components can result in serious injury or death.
•
Electrical installation, repairs and conversions may only be carried out by electrically qualified
•
persons.
•
WARNING : Danger to life due to high voltages. Forbid installation in live line.
Do NOT touch damaged components.
•
Excessive voltage can damage the solar kit.
•
•
Do NOT disconnect the solar kit under load.
•
Do NOT disconnect the loaded cables.
•
Isolate all exposed cable ends.
•
Only connect cables with connectors
•
Make sure all electrical components are in a clean state, dry and secure
•
Make sure the cabling is not under tension
Ensure wiring is not exposed and/or hanging and is protected from dirt and mould
•
•
Ensure all connectors are sealed and secure during operation.
Publicidad
