Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 4 - Remove Cover and Attach Abrasive Disc
ATTACH TABLE
Refer to Figure 5 and 6.
The included table is used with both the disc and belt.
To use the table with the disc:
• Position table on disc guard and attach using two knobs.
• Thread locking handle through tal_e and into disc guard.
• Using a combination square, set the table perpendicular
to the disc, and secure in position.If necessary, set pointer
at 0°.
Figure 5 - Using Table with Disc
To use the table with the belt:
• Position table between belt housing and disc guard. Place
the right side table slot over the stud located on the rear of
disc guard. Secure left aide of table using knob.
• Thread locking handle through table into bracket.
• Using a combination square, set the table perpendicular
to the belt and secure in position, If necessary, set pointer
at 0°,
Figure 6 - Using Table with Belt
ATTACH
DUST
COLLECTION
BAG
Refer to Figure 7,
•
Place clamp over bag sleeve.
•
Slide sleeve with clamp over the dust port.
Secure in position by tightening clamp handle. Do not
force handle. Rotate the handle to increase the clamp size.
_gure 7 - Attach Dust Collection Bag
Refer to Figures 8, 9 and 10, page 5,
POWER SOURCE
WARNING:
Do not connect sander to the power source until
all assembly steps have been completed.
The motor is designed for operation on the voltage and fre-
quency specified. Normal loads will be handled safely on volt-
ages not more than 10% above or below specified voltage,
Running the unit on voltages which are not within range may
cause overheating and motor bum-out, Heavy loads require
that voltage at motor termlnals be no less than the voltage
specified on nameplate.
•
Power supply to the motor is controlled by s single pole
locking rocker switch. Remove the key to prevent unautho-
rized use.
4
Publicidad
