Kenmore 110.81422 Manual De Uso Y Cuidado E Instrucciones De Instalación página 17

iNSTALL LEVELING LEGS
Excessive Weight Hazard
Use two or more people to move and install washer/dryer.
Failure to do so can result in back or other injury,
To avoid damaging floor, use a large flat piece of cardboard from
shipping carton. Gently place Laundry Center on its side, on the
cardboard.
1. install rear leveling legs
Push legs into holes in rear corners until they snap into place.
Check adjustability of rear legs by pushing in one leg. The
other leg should come out. Check both legs. If they do not
move freely, repeat procedure.
Examine front leveling legs; find diamond marking. Screw front
legs by hand into holes in triangular braces in front corners.
Use wrench to finish turning the legs until diamond marking is
no longer visible. Gently stand Laundry Center upright.
REMOVE FOAM PACKING
1. Pull foam packing ring out of washer
-- w __
Open the washer lid. The latch under the dryer will keep
the lid open. PuJJthe foam packing ring out of the washer.
NOTE: Keep the foam ring and use it when transporting
your Laundry Center. This packing material is used to keep
the washer tub stable during transport.
CONNECT DRAIN HOSE
Proper connection of the drain hose avoids damage to your floors
due to water leakage. To keep the drain hose from coming off or
leaking, it must be installed according to the following instructions:
iMPORTANT: To ensure proper installation, this procedure must be
followed exactly.
. Attach clamp to drain hose
Check the drain hose to see whether it is the proper length.
Wet the inside of the straight end of the drain hose with
tap water.
iMPORTANT: Do not use any lubricant other than water.
Squeeze the ears of the silver, double=wire clamp with pliers to
open. Place clamp over the straight end of the drain hose 1/4"
(6.4 mm) from the end.
F2. Attach drain hose to drain connector
- m
Open clamp. Twist hose back and forth while pushing onto
drain connector on the side of the Laundry Center. Continue
until hose contacts the ribbed stops on the cabinet. Place
clamp over the area marked "CLAMP." Release clamp.
17