Descargar Imprimir esta página

Generac 1536-1 Manual Del Propietário página 13

Ocultar thumbs Ver también para 1536-1:

Publicidad

Idiomas disponibles

Idiomas disponibles

Generac Portable Products 2,100 PSIHigh Pressure Washer
I.
2.
.
Detach spray gun and nozzle extension from high
pressure hose. Detach nozzle extension from spray
gun and remove o-ring and screen from nozzle
extension. Flush the screen, spray gun, and adjustable
nozzle extension with clean water to clear debris.
If the screen is damaged, the o-ring kit contains a
replacement in-llne filter screen and an o-ring. If
undamaged, reuse screen.
Placethe in-line filter screen into the threaded end of
the nozzle extension. Direction does not matter. Push
the screen in with the eraser end of a pencil until it
rests flat at the bottom of the opening. Take care to
not bend the screen.
4.
Placethe o-ring into the recess. Pushthe o-ring snugly
against the in-line filter screen.
5.
Assemble the nozzle extension to the spray gun, as
described earlier in this manual.
Purge
Pump of Air and
Contaminants
To remove air from the pump, follow these steps:
• Set up the pressure washer as described in "Preparing
Pressure Washer For Use". Connect the water supply
and turn water on.
•Putl the trigger on the spray gun and hold.
• When the water supply is steady and constant, engage
the safety latch.
To remove contaminants from the pump, follow
these steps:
• Set up the pressure washer as described in "Preparing
Pressure Washer For Use". Connect the water supply
and turn water on.
• Start the engine according to instructionsin "To Start
Your Pressure Washer".
• Remove nozzle extension from spray gun.
• Squeezethe trigger on the spray gun and hold.
• When the water supply is steady and constant, engage
the safety latch and attach the nozzle extension.
Nozzle
Maintenance
A pulsing sensation felt while squeezingthe spray gun
trigger may be caused by excessive pump pressure. The
principal cause ofexcessive pump pressureisa nozzle
cloggedor restricted with foreign materials, such as dirt,
etc.To correctthe problem,immediatelycleanthe nozzle
usingthe toolsincluded with your pressurewasher and
followthese instructions:
I.
2.
Shut off the engine and turn off the water supply.
Detach the nozzle extension from the spray gun. Twist
the nozzle clockwise to the stream position. Using the
supplied 2mm (5/64) allen wrench, remove the nozzle
from the end of the nozzle extension (Figure 22).
3.
Remove the in-linefilter from the other end of the
nozzle extension.
4.
Use the
wire includedin
the kit
(or a small paper clip)
to free
any foreign
material
clogging
or restricting
the
nozzle (Figure22).
5.
Usinga garden hose, remove additional debris by back
flushing
water
through
the
nozzle
extension
(Figure 23). Back flush between 30 to 60 seconds. Turn
the
adjustable
nozzle
extension to stream
spray
and
move
the nozzle
from
low to high while
flushing.
6.
Reinstall the nozzle and in-line filter into the nozzle
extension. Do Not overtighten the nozzle with the
allen wrench.
7.
Reconnect the nozzleextensionto the spraygun.
8.
Reconnect the water supply, t urn on the water,and
start the engine.
i
13

Publicidad

loading