Descargar Imprimir esta página

Generac 1536-1 Manual Del Propietário página 7

Ocultar thumbs Ver también para 1536-1:

Publicidad

Idiomas disponibles

Idiomas disponibles

Generac Portable P roducts 2,100 PSI H igh Pressure Washer
• Use fresh, clean unleadedautomotive gasolineand store in
approved, clean, covered containers. Use clean fill
funnels. Never use "stale" gasoline left over from last
season or gasoline stored for long periods.
• Clean area around fuel fill cap, remove cap.
• Slowly add "UNLEADED" regular gasoline to fuel tank.
Use a funnel to prevent spillage. Slowly fill tank to about
I/2" below the bottom of the filler neck (Figure 7).
I12" Air
Tank
• Install fuel cap and wipe up any spilled gasoline.
Connect
Hose and Water
Supply to
Pump
IMPORTANT:
You must attach all hoses before you start
the engine. Starting engine without
all hoses connected and
water supplied will damage the pump.
NOTE:
Your pressure washer comes with a quick connect
that you can use to attach the high pressure hose to either
the pump or spray gun.
• Uncoil the high pressure hose and attach the female quick
connect to one end of the hose. Attach the male quick
connect to the high pressure fitting on the pump (Figure 8).
• Attach the other end of the high pressure hose to the
high pressure outlet on the pump (Figure 9). Pull down
on the collar of the quick connect, slide onto the pump
and let go of collar. Pull on hose to be sure of a tight
connection.
• Attach the hose to the base of the spray gun (Figure 10).
Tighten by hand.
Connect
High
PressureHose
Here
• Before you connect your garden hoseto the water inlet,
inspect the inlet screen (Figure I I). Clean the screen if it
contains debris, replace it if it is damaged.DO NOT RUN
THE PRESSURE WASHER IF THE SCREENIS DAMAGED.
• Run water through the garden hose for 30 seconds to
clean out any debris. Turn off water.
IMPORTANT:
Oo Not siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
• Connect the garden hose to the water inlet. Tighten by
hand (Figure II).
CAUTION!
There MUST be at least ten feet of
unrestricted garden hose between the pressure washer
inlet and any flow shut off device, such as a 'Y' shut-off
connector or other convenience-type water shut-off valve.
Damage to pressure washer resulting from disregarding this
caution will not be covered by the warranty.
/
7

Publicidad

loading