Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable P roducts 2,100 PSI High Pressure Washer
• Place t hehandle o ntothehandle s upports already
connected to themain unit.Make sure thehotes i nthe
handle a lign withtheholes onthehandle s upports
(Figure 2 ).
Handle
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
• Insert the carriage bolt through the holes from the
outside of the unit and attach a plastic knob from the
inside of the unit. Tighten by hand (Figure 3).
I&'_ml:_ _'_TI_
=k"_l_l
• Insert the "J"hook into the second from the left slot in
the accessory tray (Figure 4).
• Pinch the chemical hose that comes out of a hole in the
unit's base and slide it into the metal clip, as shown in
Figure 5.
• Titt the unit up by the handle and attach the metal clip to
the rib on the left underside of the accessory tray
(Figure 6). Slide the chemical hose through the metal clip
so that it is tight but not kinked.
Add Engine Oil
IMPORTANT:
Any attempt to crank or start the engine
before it hasbeen properly servicedwith the
recommended oil may result in an enginefailure.
• Place pressure washer on a level surface.
• Refer to the engine owners manual to acid recommended
oil to engine.
NOTE: Check oll often during engine break-in. Refer to
engine owner's manual for recommendations.
Add Gasoline
,_
WARNING!
Never fill fuel tank indoors.Never
fill fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
,_
WARNING!
Never fill fuel tank completely full.
Providespace for fuel expansion. Wipe away any
fuel spillagefrom engine and equipment before
starting.
/
6
Publicidad
