Building - Dremel 3D45 Traducción De Las Instrucciones Originales

CONNECTING USB CABLE
1. Ensure 3D45 power switch is in the off position.
2. Connect the included USB cable to your 3D45 and
computer, figure 5.
3. Open software.
4. Turn your Dremel 3D45 on using the power switch
to sync your computer to your Dremel 3D45.
CONNECTING ETHERNET
1. Ensure 3D45 power switch is in the off position.
2. Plug ethernet cable into your 3D45, figure 6.
3. Turn your Dremel 3D45 on using the power
switch. Ethernet connection should be detected
automatically. Tap "Accept" to confirm connection.
FIG. 5
FIG. 6
USB
Ethernet
WARNING
!
INSTRUCTIONS WHEN USING THE DREMEL 3D45.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
WARNING
!
OPERATION. Contact with Dremel 3D45 moving parts
during operation may result in poor build quality,
equipment damage or personal injury.
NOTE: Your Dremel 3D45 will build test objects before
leaving the factory. These test objects may have been
made with a different filament color than you are
using. Therefore, a small amount of filament may be
remaining in the extruder. The start of your first object
may have some of this filament color until it transitions
over to your filament color.
You have several options when building on your 3D45:
1) On-Printer Storage
2) USB Flash Drive
3) Queue
4) Computer
24

BUILDING

OBSERVE ALL PROVIDED
WARNINGS AND SAFETY
DO NOT REACH INSIDE THE
DREMEL 3D45 WHILE IT IS IN