Removing Your Object - Dremel 3D45 Traducción De Las Instrucciones Originales

REMOVING YOUR OBJECT

REMOVING YOUR OBJECT FROM THE BUILD
PLATFORM
DO NOT TOUCH THE EXTRUDER
WARNING
!
TIP OR HEATED BUILD
PLATFORM DURING DREMEL 3D45 OPERATION OR
UNTIL IT HAS COOLED DOWN TO AT LEAST 60°C
(140°F). Contact with the extruder tip or build
platform during or after operation before tip and build
plate has cooled may result in personal injury.
USE PERSONAL PROTECTIVE
WARNING
!
EQUIPMENT. The use of
protective equipment such as heat resistant gloves
and safety glasses will reduce personal injuries.
BE AWARE OF YOUR BODY
WARNING
!
POSITION WHEN USING HAND
TOOLS TO REMOVE OBJECTS FROM THE BUILD
PLATFORM. Sudden tool slip and improper body
position during object removal from the build
platform may result in personal injury.
DO NOT DROP THE BUILD
WARNING
!
PLATFORM. Tempered glass plate
may break and result in personal injury.
DO NOT TWIST OR BEND THE
WARNING
!
BUILD PLATFORM WHILE
REMOVING OBJECTS. Tempered glass plate may
separate from plastic holder and result in personal
injury.
AVOID SCRATCHING THE BUILD
!
PLATFORM WHEN REMOVING
OBJECTS. SCRATCHES IN THE BUILD PLATFORM
WILL RESULT IN IMPROPER OBJECT CREATION.
1. Wait for the extruder to cool before removing your
object.
2. With the object still attached, remove build platform
from the build area.
3. Peel your object from the build platform. If needed,
gently use the object removal tool to remove object
from build platform (figure 8).
REMOVING SUPPORTS (IF REQUIRED)
Use needle nose pliers to remove supports that are
inside your object or hard to reach.
Removal Tool
27
FIG. 8