Best Practices; Maintenance - Dremel 3D45 Traducción De Las Instrucciones Originales

BEST PRACTICES

1. ALWAYS USE PROVIDED GLUE STICK.
2. Ensure your build platform is level before every
print.
3. For proper adhesion of filament to the build
platform, regularly wash the glue from the build
platform with warm water, dry the build platform,
re-apply a fresh layer of glue and re-level.
4. Ensure spool is installed properly and can rotate
freely.
5. When using your Dremel 3D45 for the first time
or after changing filament, allow Dremel 3D45 to
extrude until material is consistent with the installed
filament color.
6. It is important to watch your Dremel 3D45 begin
building objects. Your object is most likely to
experience difficulty in the beginning. Thankfully,
this is also the most convenient time to cancel
the object, clean the build platform, and start your
object again. Remain near the Dremel 3D45 during
the building process.
7. It is important to save your Dremel 3D45 packaging
as it will make re-boxing and transporting your
Dremel 3D45 easier.
8. Ensure that you store filament spools in an
environment that is not moist or too hot. It is
recommended that you do not remove the filament
spool from its airtight packaging until use.
9. Use object removal tool gently to avoid damaging
the build platform or object.
10. Whenever possible, it is best to locate your object
in the center of the build platform. Using the best
orientation for your object is critical. Ensure that
your object is located on the build platform and that
you are using the best orientation for building.
11. For steep overhangs (Less than 45 degree angle) it
is recommended to build with support.
12. Always remove the build platform before removing
the object.

MAINTENANCE

UNCLOGGING THE EXTRUDER
Use the unclogging tool to clean the extruder and
unclog built up filament, fig 9.
1. Click on the filament change button on the screen
and wait for extruder to heat up. As filament starts
to purge, insert the unclog tool into the extruder
intake (top).
2. Clogged debris will be pushed down and will
extrude from the extruder tip. You should push the
unclog too all the way down to ensure all filament
is purged. You do not need to push with excessive
force, as this may damage the extruder.
28
FIG. 9