Industrial Air 024-03971A Manual Del Usuario página 4

FITTINGS INSTALLATION C0NTINUED
Note: Make sure shoulder of fitting is fully seated against pipe. If you cannot seat
the fitting properly apply soapy water to help this process.
4. Tighten the nut by using your fingers. Draw a reference mark on the fitting
and nut.
5. Tighten nut with a wrench ¾ turn minimum or until tight. If you have to
remove the fitting, loosen the nut, remove the split ring and pull the fitting off
the tube. Before reassembling be sure to inspect the split ring and O-ring for
damage and replace if necessary.
NOTE: Do not over tighten. Damage may occur to the pipe if nut is overtightened.
1
4
TYPICAL LAYOUT
to air tank
4 - ENG
2
5
3