Dreame VTE1 Manual De Usuario página 10

Care & Maintenance
EN
3. Remove the pre-filter first, then lift the handle of the cyclone assembly and turn to
counterclockwise until it stops, then pull to lift out the cyclone assembly.
1
4. Rinse the cyclone assembly, pre-filter and dust cup until they are clean. After washing,
air dry at least 24 hours .
Dust Cup
Note:
• It is recommended to clean the dust cup once every month.
• It is recommended to clean the pre-filter at least once every 3 months and the cyclone
system at least once every 6 months.
14
2
3
12
11 1
10 2
24 hrs
9 3
8 4
7 5
6
Cyclone Assembly Pre-filter
Care & Maintenance
Installing the Dust Cup, Pre-Filter, and Cyclone Assembly
1. Insert the cyclone assembly vertically into the dust cup, and make sure that the handle of
the cyclone assembly line up with the slot on the left side of the dust cup. Turn the handle
clockwise until it locks, then flip the handle down.
2. Place the pre-filter with its front side facing up into the cyclone assembly.
3
1
3. Slightly tilt the dust cup so the slot aligns with the clip on the vacuum. Then gently push
the dust cup until it clicks into place.
2
3
EN
15