Dreame VTE1 Manual De Usuario página 7

Installation
EN
2-in-1 Charging & Storage Mount Installation Diagram
The 2-in-1 charging & storage mount is an optional accessory. You can install it based on
your needs.
1. The 2-in-1 charging & storage mount should be installed in a cool, dry place with an
electrical outlet nearby. Prior to installing, ensure that there are no electrical wires or
pipes in the space directly behind where the mount will be installed.
2. The bottom of the mounting template sticker should be level and at least 103cm from
the ground, and its top should have at least 30cm* of clearance above it. (*30cm: Leave
enough space just in case you may need to purchase the replaceable battery in the
future.)
3. Use a power drill with an 8 mm drill bit to drill a hole into each hole marker on the
mounting template sticker, then insert a wall plug into each hole.
4. Align the position holes on the mount with the holes on the wall. Fasten it to the wall with
the included screws.
8
30 cm
103 cm
Charging
Fully charge the vacuum before using it for the first time.
Note: A full charge will take approx. 4 hours. Using Turbo Mode for a prolonged period will
cause the battery to heat up, which increases charging time. Allow the vacuum to cool
down for 30 minutes before charging it.
Charging Methods
Charging the vacuum with the charger
Battery Status Display
Display Screen
The number on the display screen
represents the current battery level in a
percentage during charging. When the
number turns into 100, the battery is fully
charged.
Charging the vacuum on the charging
mount
2
LED Battery Status Indicator
When charging, the three indicators flash
and then turn bright constantly in sequence
considering the battery condition. When the
charging is completed, the three indicators
keep solid light.
Note: Once the vacuum is fully charged, the
indicator will turn off after 5 minutes, and
the vacuum will enter the energy-saving
mode.
EN
9