Dreame VTE1 Manual De Usuario página 14

FAQ
EN
If the vacuum is not working properly, please refer to the troubleshooting table below.
Errors Possible Causes
Vacuum is out of battery or
low on power.
Vacuum does
Overheat protection mode
not work.
triggered by a blockage.
Suction opening or air duct is
blocked.
Dust cup is full and/or filter
assembly is clogged.
Weak suction
force.
Attachment is blocked.
Motor makes a Main suction opening or
strange noise. extension rod is blocked.
The first indicator
is red after turning
Battery pack is damaged.
on the vacuum.
The first
indicator blinks
The charger is incompatible.
red when
charging the
vacuum.
22
Solutions
Fully charge the vacuum, then
resume use.
Clean the suction openings or air
duct. Wait until the vacuum cools
down, then reactivate it.
Clear any blockage from suction
opening or air duct.
Empty the dust cup and clean the
filter assembly.
Clear any blockages in the
attachment.
Clear any blockage in the main
suction opening or extension rod.
Please contact after-sales service
department to arrange mainte-
nance.
Only use the original charger to
charge the vacuum.
FAQ
Errors Possible Causes
The charger does not plug into
the vacuum well.
The battery
The battery is charged and
indicator does
switches to Sleep Mode
not light up when
automatically.
charging.
If the problem persists after
ruling out the above two
possibilities.
Battery temperature is too low
Charging too
or too high.
slow
The lithium-on battery pack contains substances that are hazardous to the environment.
Before disposing of the vacuum, please first remove the battery pack, then discard, or recycle it
in accordance with local laws and regulations of the country or region it is used in.
Solutions
Check whether the charger is
properly plugged into the vacuum.
The vacuum runs normally.
Please contact the after-sales service
department for maintenance.
Wait until the battery's temperature
returns normal, then resume use.
23
EN