Publicidad
Idiomas disponibles
Idiomas disponibles
English
6 - Connection and wiring
6.1 - IP67 plugs :
CAUTION !
The projector is fitted with molded IP67 hybrid plugs.
These plugs guarantee a good seal of the product. Cutting the plugs will void
the projector warranty if water ingress occurs.
The projector is delivered with a bare wire adapter to IP67 IN connector in
order to connect to an IP junction box.
1
3
L
N
Power : Alimentation Wire color : Code couleur
L : Live : Phase
Brown : Marron
N : Neutral : Neutre
Blue : Bleu
Ground : Terre
Yellow/green : Jaune/vert
Water may be sucked into the interior of the projector due to vacuum caused by temperature changes in the projector. Ensure that the projector
is protected against water ingress through the cables by using connectors or junction boxes that meet at least IP66. Create a drip loop before
the cable glands or connection points to prevent them from being constantly immersed in water as shown in the figure below.
6.2 - Indoor line cabling with VC-ADAPT:
To power your line of indoor projectors, you can use the VC-ADAPT adapter cord which has a 2P+E power plug for the power supply and an
XLR plug for the DMX and which comes out on a Power+DMX hybrid plug as shown in the figure below.
Power
DMX
Page 18
The plugs are equipped with three pins for the power supply and three pins for the
DMX signal. The hybrid cable is used for the power supply part in 3 x 1.5 mm² and
1
3
for the isolated DMX part in a separate sheath. The color code of the corresponding
N
L
wires is shown in the diagram opposite.
DMX
Wire color : Code couleur
1 : Masse
Black : Noir
2: Data -
White : Blanc
3 : Data +
Red : Rouge
IN
VC-ADAPT
VH2O-90 - IP66 color water effect architectural projector
CAUTION !
The plugs mounted on the projector cables are IP67, so
they are waterproof but it is not recommended to leave
them in standing water.
OUT
IN
CAUTION !
Risk of electic choks
Do not plug or unplug any
cables while the system is
powered on.
OUT
Publicidad
