Craftsman 172.11624 Manual Del Propietário página 12

ATTACHING SANDING SHEETS A NDPADS (See Figs.8,9)
This sander
f eatures an easy hook and loop accessory fastening system for
quickchanging without clamps,
1. Unplug the sander.
L WARNING:
Failure to unplug the sander could result in accidental I
starting causing possible serious personal injury.
I
2. Carefully center the sanding
sheet or pad over the base to be
used. Une up the tip of the
sanding sheet or pad with the tip
of the base.
3, Press the sheet or pad firmly in
place.
4. To remove sheet or pad, simply
pull it off.
Fig. 9 Base
Tip of
SANDING WITH EITHER BASE
(See Fig. 10)
1. Always hold the sander as shown
in figure 10.
2. Move the sander in long,
sweeping strokes across the
sanding surface.
3. Light pressure is all that is
needed for sanding, polishing
and scrubbing.
Let the sander do the work.
Fig. 10
IMPORTANT: Applying excessive pressure will slow the sander and produce
unsatisfactory results,
4. Check your work often. This sander removes material quickly.
12