cecotec BOLERO COOLMARKET TT B1 121 E Manual De Instrucciones página 55

3. PLACE OF INSTALLATION
1. Conditions for proper ventilation
The location you choose for the installation of the refrigerator must be properly ventilated and
away from heat sources. Do not place the refrigerator near heat sources, like a cooker hob or
pot, and avoid direct sunlight to ensure the cooling effect and save on energy consumption. Do
not place the refrigerator in a damp place to avoid rust or loss of cooling performance, and do
not expose it to rain.
Note:
The amount of refrigerant used by the refrigerator is specified on the appliance marking.
2. Installation instructions
- Before installation, please read the instructions carefully to avoid any problems.
- Figure 2 shows the dimensions of the mounting space.
- Place the refrigerator on a solid, flat surface to keep it stable, otherwise vibrations and
noises will occur. When the refrigerator is placed on a carpet, straw mat, or polyvinyl
chloride, solid support plates should be placed under the refrigerator to avoid colour
change due to heat dissipation.
- It is necessary to maintain unobstructed ventilation around the appliance or in the
structure where it is installed .
3. Reversing the refrigerator door
- The opening side of the door can be changed from the right side to the left side if the
location of the appliance requires it.
- Warning! Be careful when reversing the door.
- The appliance must not be connected to a mains socket. Make sure it is unplugged from
the power supply.
- Necessary tools (not included).
a. Crosshead screwdriver.
b. Flat-head screwdriver.
c. Fixed spanner 8 mm.
NOTE: When necessary, tilt the refrigerator backwards to gain access to the base, the appliance
should be placed on soft foam packaging or similar material to avoid damaging the back of the
refrigerator. To reverse the door, the following steps are generally recommended.
1. Place the refrigerator in an upright position. Open the door and remove the top hinge
protector (left and right). Remove the bottom screw hole protector from the refrigerator.
Remove the door screw hole protector (Fig. 3).
ENGLISH
Bolero CoolMarket TT B1 121 E
55