Publicidad
For low pressure operation, extend the
nozzle of the multi-adjustable
spray
wand as shown.
low
pressure
The powerful spray
from your pressure
washer is capable of causing damage
to surfaces such as wood, glass,
automobile paint, auto striping and
trim, and delicate objects such as
flowers and shrubs. Before spraying,
check the item to be cleaned to
assure yourself that it is strong
enough to resist damage from the
force of the spray.
HOW TO APPLY CHEMICALS
AND CLEANING
SOLVENTS
Applying chemicals or cleaning
solvents is a low pressure operation.
NOTE: Use only soaps and chemicals
designed for pressure washer use. Do
not use bleach.
To Apply chemicals:
1.
Press chemical hose onto barbed
fitting located near high pressure
hose connection of pump as
shown.
2.
Place other end of chemical hose
with filter on it into container holding
chemical/cleaning
solution. NOTE:
The chemical/water ratio is 7:1, for
every 7 gallons of water pumped 1
gallon of chemical/cleaning
solution
will be used.
3.
Install low pressure (black)
nozzle into quick connect fitting of
spray wand, see How To Use Spray
Wand paragraph in this section.
4.
After use of chemicals,
place
chemical hose into container of
clean water and draw clean water
through chemical injection system
to rinse system thoroughly. If
chemicals remain in the pump it
could be damaged. Pumps
damaged due to chemicals will not
be covered under warranty.
NOTE: Chemicals and soaps will not
siphon when spray wand is in the high
pressure setting.
TO SHUT
DOWN
IMPORTANT: Read and understand
how to shut down the pressure
washer before operating.
1.
If you have applied chemicals,
place chemical hose into container
of clean water and draw clean
water through chemical injection
system to rinse system thoroughly.
NOTE: Failure to do so could
cause damage to the pump.
2.
Turn engine off by placing the
throttle control in the OFF
position.
NOTE: NEVER turn the water off
with the engine running.
3.
Turn the fuel valve to the OFF
position if engine will not be
restarted soon.
4.
Turn water source off.
5.
Pull trigger on spray gun to relieve
any water pressure in hose or
spray gun.
6.
See Storage section in this
manual for proper storage
procedures.
11- ENG
AO4549
Publicidad
