Publicidad
8.
Pull engine starter rope slowly
several times until antifreeze
comes out of high pressure hose
connection
of pump.
9.
Remove short hose from water
inlet of pump.
10. Reconnect spark plug wire.
*Windshield washer fluid may also be
used
PROBLEM
Engine will not
start
No or low
pressure
(initial use)
1.
2.
3.
4.
5.
CAUSE
No fuel.
Pressure builds up after
two pulls on the recoil
starter or after initial use.
Not choked.
Spark plug wire not
attached.
Choke lever in the
"Choke" position on a
"hot" engine or an engine
that has been exposed to
thermal heat for a long
CORRECTION
1.
Add Fuel.
2.
Squeeze gun trigger to
relieve pressure.
3.
Choke engine, place engine
in the choke position.
4.
Attach spark plug wire.
5.
Move choke to the "No
Choke" position.
period of time.
6.
Fuel valve closed
1.
Wand not in high
pressure.
2.
Low water supply.
3.
Leak at high pressure
hose fitting.
4.
Nozzle obstructed.
5.
Water filter screen
clogged.
6.
Move the fuel valve knob to
the "Open" position.
1.
See How to Use Spray
Wand paragraph in the
Operation Section.
2.
Water supply must be at
least 5 GPM @ 20 PSI.
3.
Tighten. Apply sealant tape
if necessary.
4.
See Spray Wand
paragraph in the
Maintenance section for
the correct procedure.
5.
Remove and clean filter.
A04549
18- ENG
Publicidad
