Publicidad
Idiomas disponibles
Idiomas disponibles
Unpacking the Table Saw
(Fig. 2, Fig. 3, Fig. 4)
To avoid injury from unex-
pected starting during un-
packing and setting up, do not insert the Bat-
tery Pack.
If any parts are missing, do
not attempt to assemble the
table saw, insert the Battery Pack, or turn the
Power Switch on until the missing parts are
obtained and are installed correctly.
Your table saw is shipped complete in one car-
ton.
Separate all parts from the packing materials,
and check each one with the illustration and
the list of loose parts to make certain all items
are accounted for before discarding any packing
material.
Loose Parts (Fig. 2)
Item
Description
A
Table Saw Assembly
B
Barrier Guard Assembly
C
Anti-Kickback Device
D
Miter Gauge
E
Table Insert
Parts Stowed on Saw (Fig. 3)
F
Rip Fence
G
Hex Wrench
H
Push Stick
I
Blade Wrench
Items to Be Removed (Fig. 4)
J
Styrofoam Block
NOTE: Tilt the saw up to gain access to the un-
derside of the saw and remove the Styrofoam
Block J (which is included for shipping purpos-
es only) that is located between the underside
of the Table 13 and the Motor 20. If the Styro-
foam Block is not removed, you may cause dam-
age to the blade elevation system when trying to
raise the Blade.
1609B07947GTS18V-08 OSI 08-2022.indd 16
Unpacking and Checking Contents
Qty.
1
1
1
1
1
1
1
1
1
1
Fig. 2
D
E
Fig. 3
Fig. 4
-16-
B
C
A
H
F
I
G
J
20
8/3/22 2:44 PM
Publicidad
