Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
!
It is important to use the factory provided grille that came
with the product to assure proper air flow is maintained
through the condenser. The use of a custom grille is not
recommended and will void the warranty.
Full Overlay Panel Installation Instructions
Determine Wood Screw Requirements
1. A #10 pan head wood screw should be used to proper-
ly secure the overlay panel (See Figure 14). A quantity
of 16 screws are supplied with the unit in the literature
pack.
2. Use only pan head screws.
3. If your overlay panel is thinner than
you will need to purchase shorter screws. The longer
screws will break through the front of the panel.
Step 1: Remove Drawers from unit.
1. Begin by pulling out the top drawer. (See Figure 11).
Remove screws securing drawer to slides (See Figure
12). Pull drawer forward, lift up and out to clear clips in
rear of drawer. Move drawer forward about 1" (2.5 cm)
and set down on slides. At the right rear corner of the
drawer disconnect the display wire harness (See Figure
11a). Remove the drawer from the unit by lifting up off
of the slides. Repeat for bottom drawer but disregard
the harness instructions as there is no wiring to the bot-
tom drawer.
2. Remove the gasket from the drawer front. (See Figure
12). Do this by pulling the gasket out of the channel
that holds it to the drawer front. This will expose the
clearance holes for mounting the overlay panel. (See
Figure 16).
OVERLAY DRAWER PANEL INSTALLATION
⁄
" (15.9 mm)
5
8
Figure 11
!
Electrocution Hazard
• Never attempt to repair or perform maintenance on
the appliance until the main electrical power has been
disconnected. Turning the appliance control "OFF"
does not remove electrical power from the units wiring.
• Replace all parts and panels before operating.
Remove screws
Clips
Figure 11a
13
WARNING
Figure 12
Figure 13
Press and hold down this
tab on the wire connec-
tor and pull the connector
apart.
Gasket
Publicidad
