Publicidad
Idiomas disponibles
Idiomas disponibles
For proper orientation of shield, see
KNOW YOUR TRIMMER illustration in OP-
ERATION section.
1.
Remove wing nut from shield.
2.
Insert bracket into slot as shown.
3.
Pivot shield until bolt passes
through hole in bracket.
4.
Securely tighten wing nut onto
bolt.
Shield
line Umiter Blade
Slot
Bracket
\
Wing
Nut
KNOW YOUR TRIMMER
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize
yourself with the location
of the various controls and adjustments. Save this manual for future reference.
Assist Handle
Tube
Muffler
ON/STOP
Trigger
Switch \
_
Spark Plug
OhokeLever
Sh,
Fuel Mix
IB, L.7 ''=-----
Fill Cap
Tdmmer
Head
Edge
Gutde
t
Limiter
Blade
ONISTOP
SWITCH
The ON/STOP switch is used to stop en-
gine. To stop the engine, push and re-
lease the engine ON/STOP switch.
PRIMER
BULB
The PRIMER BULB removes air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
' by pressing it and allowing it to return
to its original form.
CHOKE
The CHOKE helps to supply fuel to the
engine to aid in cold starling. Activate
the choke by moving the choke lever to
the FULL CHOKE position. After the en-
gine attempts to start, move the choke
lever to the HALF CHOKE position. Once
engine has started, move the choke le-
ver to the OFF CHOKE position.
EDGE GUIDE
The EDGE GUIDE protects the unit
from contacting the ground during
edging.
BEFORE
STARTING
ENGINE
WARNING:
Be sure to read
the fuel information in the safety rules
before you begin. If you do not
understand the safety rules, do not
attempt to fuel your unit. Call
1°800-235-5878.
FUELING
ENGINE
_WARNING:
Remove fuel cap
slowly when refueling.
This engine is certified to operate
on
unleaded gasoline. Before operation,
gasoline must be mixed with a good
quality synthetic 2-cycle air-cooled
5
Publicidad
