Vortice NORDIK ECO Manual De Instrucciones página 6

ENGLISH
Description and use
The product you have purchased is a reversible ceiling
agitator fan unit with a maximum operating temperatu-
re of 45°C.
NORDIK ECO series units have
been designed for household use.
NORDIK ECO series units have been designed for
household installation and use. They are also suitable
for installations in Commercial or Industrial areas pro-
vided environmental conditions are not particularly
aggressive (i.e. corrosive, dusty environments, etc.).
Models:
Nordik Eco 90/36"
Nordik Eco 120/48"
Nordik Eco 140/56"
Nordik Eco 160/60"
Nordik Eco 180/70"
Nordik Eco 200/80"
Warning:
!
this symbol indicates that care must
be taken to avoid injury to the user
• Do not use this product for functions other than
those described in the instruction booklet.
• After having removed the product from its packing,
ensure that it is complete and undamaged: if indoubt
contact Vortice Service Centre.
• Do not leave packaging within the reach of children
or differently able persons.
• Certain fundamental rules must be observed when
using any electrical appliance:
- Never touch appliances with wet or damp hands
- Never touch appliances while barefoot
• Do not use the appliance where flammable vapours
are present (spirit, insecticides, petrol, etc.).
• To conform with applicable standards, the bottom
edges of the fan blades must be at a height of at least
2.7 metres or more from the floor (fig.1) in non-
residential premises.
• Unauthorised changes to the factory set fittingshall
invalidate the guarantee and entitle the manu-
facturer to disclaim any whatsoever liability.
6
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Regularly inspect the appliance for visible defects. If
any faults are found, do not operate the appliance but
contact Vortice Service Centre.
• The electrical mains to wich the unit is connected
must conform to current standard.
• The appliance must be properly connected to an
electrical system in compliance with the applicable
regulations and equipped with an efficient earthing
system. If in doubt, have a qualified electrician
perform a thorough check.
• The electrical power source to which the product isto
be connected must be able to provide the maximum
amount of electrical power required by the product.If
it cannot do this, contact an electrician for
appropriate remedial action.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice.
• If the appliance does not function correctly or
develops a fault, turn it off and contact Vortice
immediately. Ensure that only genuine original
Vortice spares are used for any repairs.
• Do not leave the appliance on unnecessarily: when
the appliance is not in use, turn the switch to off.
• Place the unit at a suitable distance from
walls,objects, etc.
• Specifications for the power supply must correspond
to the electrical data on data plate A (fig.2).
Tools needed for assembly
Figure A
Supplied accessories
Figure B
Installation
Figures: 4 ÷ 50
Please follow the instructions below for installation.
1. Make sure that the ceiling where the unit is to be
installed is structurally sound to support the weight
of the product.
2. Be careful that the anchoring devices do not com-
promise the structural resistance of the ceiling where
the unit is to be installed.
3. Use dowels that can ensure material stays gripped
to the ceiling where the unit is to be installed.