Craftsman 139.53939D Manual Del Propietário página 30

OPERATION
IMPORTANT SAFETY INSTRUCTIONS
To reducethe risk of SEVERE INJURYor DEATH:
1. READAND FOLLOWALL WARNINGSAND INSTRUCTIONS.
2. ALWAYS keep remote controls out of reach of children.
NEVERpermit children to operate or play with garage door
control push buttons or remote controls.
3. ONLYactivate garage door when it can be seen clearly, it is
properly adjusted, and there are no obstructions to door
travel.
4. ALWAYS keep garage door in sight until completely closed.
NO ONESHOULDCROSSTHE PATH OFTHE MOVING
DOOR.
5. NO ONESHOULDGO UNDERA STOPPED,PARTIALLY
OPENDOOR.
6. If possible, use emergency releasehandle to disengage
trolley ONLYwhen garage door is closed. Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly, causing SEVERE
INJURY or DEATH.
7. NEVERuse emergency release handle unless garage
doorway is clear of persons and obstructions.
8. NEVERuse handle to pull garage door open or closed. If
rope knot becomes untied, you could fall.
9. If one control (force or travel limits) is adjusted, the other
control may also need adjustment.
10. After ANY adjustments are made, the safety reversal
system MUST be tested.
11. Safety reversal system MUST be tested every month.
Garagedoor MUST reverse on contact with 1-1/2"
(3.8 cm) high object (or a 2x4 laid flat) on the floor.
Failureto adjust the garage door opener properly may
cause SEVEREINJURYor DEATH.
12. ALWAYS KEEPGARAGEDOORPROPERLY BALANCED
(see page 3). An improperly balanced door may NOT
reverse when required and could result in SEVEREINJURY
or DEATH.
13. ALL repairs to cables, spring assemblies and other
hardware, ALL of which are under EXTREMEtension,
MUST be made by a trained door systems technician.
14. To avoid SERIOUSPERSONALINJURYor DEATHfrom
electrocution, disconnect ALL electric and battery power
BEFORE performing ANY service or maintenance.
15SAVETHESEINSTRUCTIONS.
Using Your Garage Door Opener
Your Security.I-® opener and hand-held remote control have
been factory-set to a matching code which changes with each
use, randomly accessing over 100 billion new codes. Your opener
will operate with up to ten Security.I-® remote controls, one
Security.I-® KeylessEntry System, and one accessory wall
control. If you purchase a new remote, or if you wish to
deactivate any remote, follow the instructions in the
Programming section.
Activateyour opener with any of the following:
• The Hand-Held Remote Controh Hold the large push button
down until the door starts to move.
• The Waft-Mounted Door Control: Hold the push button or bar
down until the door starts to move.
• The KeylessEntry (seeAccessories): If provided with your
garage door opener, it must be programmed before use. See
Programming.
Whenthe opener is activated (with the safety reversingsensor
correctlyinstalled and aligned)
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop.
4. If the door has been stopped in a partially open position,
it will close.
5. If obstructed while closing, the door will reverse. If the
obstruction interrupts the sensor beam, the opener lights will
blink for five seconds.
6. If obstructed while opening, the door will stop.
7. If fully open, the door will not close when the beam is broken.
The sensor has no effect in the opening cycle.
If the sensor is not installed, or is misaligned, the door won't
close from a hand-held remote. However, you can close the door
with the door control or KeylessEntry, if you activate them until
down travel is complete. If you releasethem too soon, the door
will reverse.
The openerlights will turn on under the following conditions:
when the opener is initially plugged in; when power is restored
after interruption; when the opener is activated.
They will turn off automatically after 4-1/2 minutes or provide
constant light when the Light feature on the Smart Control Panel ®
is activated. Bulb size is A19. Bulb power is 100 watts maximum.
Security.i_ light feature: Lights will also turn on when someone
walks through the open garage door. With a Smart Control
Panel ¢, this feature may be turned off as follows: With the opener
lights off, press and hold the light button for 10 seconds, until the
light goes on, then off again. To restore this feature, start with the
opener lights on, then press and hold the light button for
10 seconds until the light goes off, then on again.
3O