Publicidad
Idiomas disponibles
Idiomas disponibles
•
This device may not cause harmful
interference, and
•
This device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving
antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced
radio/TV technician for help.
CAUTION:
Any changes or modifications not expressly
approved by the grantee of this device could
void the user's authority to operate the
equipment.
RF exposure warning
This equipment must be installed and
operated in accordance with provided
instructions, and the antenna(s) used for this
transmitter must be installed to provide a
separation distance of at least 20 cm from
all persons and must not be co-located
or operating in conjunction with any other
antenna or transmitter.
End-users and installers must provide
antenna installation instructions and
transmitter operating conditions for satisfying
RF exposure compliance.
CANADA
Industry Canada statement
This device contains license-exempt
transmitter(s)/ receiver(s) that comply
with Innovation, Science and Economic
Development Canada's license-exempt RSS(s).
Operation is subject to the following two
conditions:
1.
This device may not cause interference,
2.
This device must accept any interference,
including interference that may cause
undesired operation of the device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless
Device is below the Innovation, Science and
Economic Development Canada (ISED) radio
frequency exposure limits. The Wireless
Device should be used in such a manner such
that the potential for human contact during
normal operation is minimized. This device
has also been evaluated and shown compliant
with the ISED RF Exposure limits under
mobile exposure conditions (antennas are
greater than 20 cm from a person's body).
Publicidad
