Rt Gearshift; Rs Gearshift - Sunrise Medical shark rs Manual De Usuario

turning at the maximum angle, the increased
knee bend does not lead to contact with the
drive crank. There must be a gap of at least
5 cm between the heel and the floor. You will
need this leeway when travelling round corners.
When finished, make sure that
all screws have been properly tightened (see
the page on torque).
The footrest tubes for longer legs are always
delivered at the maximum length. The customer
can then shorten them to the required length.
After shortening the tube, you must always
ensure that the footrest tube is pushed into the
fork far enough so that both fixing screws touch
the footrest tube.
CauTION!
Never use the leg support to lift the hand bike.
before use, you must secure your feet into
the footrests.
If your feet accidentally come out
when you are riding, this can lead to serious
injuries.

RT gearshift

Chain gearshift/hub gearshift (Fig. 4.10 -
4.11)
Gear shift is carried out using the Grip Shift
switch, which can be mounted either on the
frame, the fork or the handle.
Shifting the upper chain rings on the crank is
carried out using a lever which is mounted on
the crank housing.
The chain gearshift enables you to easily keep
moving, regardless of other road conditions.
A description of the gear change unit is
included as part of the delivery. If the gearshift
suddenly does not operate smoothly, please
contact your dealer!
Rs gearshift (Fig. 4.12)
This is carried out using the trigger switch on
the right handle or the Dual Control switch on
the right-hand side of the fork.
10
SHARK RS / RT
Fig. 4.8
Fig. 4.9
Fig. 4.10
Fig. 4.11
Fig. 4.12