SAKAWA CS2500 Manual Del Usuario página 95

LOW POWER
Problem
Does the engine overheat?
The engine pounds or makes
noises
The engine does not operate
normally
at all speeds.
Black smoke or
carbureted fuel comes out of
the exhaust pipe.
Note: if the engine still does not work, take the machine to a technical service.
Transport and storage.
TRANSPORT
• Never transport the machine while the engine is running.
• Wait 5 minutes after turning off the engine before transporting the machine.
•
Yes You are going to transport the machine in a vehicle Secure it firmly to prevent it from
slipping or tipping over and with the protector on the cutting elements.
STORAGE
• Do not store the machine near flammable materials (dry grass, wood...), gas or fuels.
•
Store this tool in a place not accessible to children and safe so that it does not endanger
any person and that it is dry, clean and at a temperature between 0ºC and 45ºC.
• Always store the machine with the cutting element protection installed.
•
Yes You will store the machine in an enclosed place empty the fuel. If the fuel tank has
to be emptied this should be done outdoors and following recycling regulations.
• Storage from 30 days without use:
1. Clean the external parts thoroughly and apply a light layer of oil to all metal surfaces.
2. Remove the spark plug and put about 3 ml of oil in the cylinder through the hole in the spark
plug. Slowly pull the starter cable 2 or 3 times so that the oil evenly covers the inside of the engine.
Reinstall the spark plug.
Cause
The operator
operating with the machine.
The carburetor mixture is too
poor.
The fan, fan cover, or cylinder
is dirty or damaged.
It is overheated.
Wrong fuel.
Coal pits in the combustion
chamber.
There are carbon grounds in
the piston or muffler.
The air filter element is stuck.
non-
The spark plug is loose or
damaged.
Air is leaking or the fuel line is
stuck.
There is water in the fuel. The
piston catches on.
Defective carburetor and/or
diaphragm.
The fuel mixture for a two-
stroke engine is incorrect.
95
Solution
is over
Cut at a slower speed.
Take the
Technical Service
Official.
Clean or replace as needed.
Check that the fuel is of the
correct octane, check that
there is no alcohol in the fuel.
Refill the machine with the
correct fuel.
Take the
Technical Service
Official.
Clean or replace the air filter.
Tighten or replace the spark
plug and restart the machine.
Repair or replace the fuel filter
and/or fuel line.
Refill the tank with a correct
fuel/oil mixture.
Take the machine to an
authorized Technical Service.
machine to a
machine to a