Elcometer PP10T Manual De Instrucciones página 15

Never exceed the maximum operating pressure. The equipment units are calibrated by the
manufacturer in accordance with the design performance features described in their technical
specifications.
As a general, preventive measure we advise you to wear goggles in accordance with the
specific environmental regulations and characteristics for the work centre.
Wear gloves when handling the product (see the manufacturer's recommendations) and
clean the gun.
If, when the gun is in use, the ambient noise level exceeds 85 dB (A) the use of approved
ear protectors is required.
The unit in itself does not propitiate any mechanical risk of perforations, impact or pinching, except
those deriving from incorrect installations and handling.
USE ELCOMETER ANTI-STATIC HOSES TO ELIMINATE POSSIBLE
ELECTRICAL SHOCK THAT MAY LEAD TO A RISK OF FIRE OR EXPLOSION
Pay adequate attention when handling the unit in order to prevent any damage that might lead to
dangerous situations for the user or personnel standing near the unit, as a consequence of leaks,
breakages, etc.
The equipment has been designed for use at room temperature. The maximum operating
o
temperature is 50 C.
The use of solvents and/or detergents that contain halogenated
hydrocarbons (trichloroethane, methyl chloride, etc.), may cause
chemical reactions in the unit as well as in its zinc-coated components
(trichloroethane mixed with small amounts of water produces
hydrochloric acid). For this reason, these components may rust and
in extreme cases the chemical reaction caused may be explosive. We
recommend you to use products that do not contain the aforementioned
components. Do not use acids, soda (alkalis or pickling substances,
etc.) for cleaning under any circumstances.
In general, precautions must be taken whenever the unit is handled, in order to prevent any damage
to this.
Connectors must be securely tightened and in good condition. If pneumatic connectors are fitted,
they must comply with the standard ISO 4414:2010.
Safety standards must be understood and applied.
Any non-compliance with the indications set out in this manual may lead to incidents affecting the
physical integrity of the user or other personnel or animals.
Respect and comply with indications relating to the conservation of the environment.
Always keep the safety sheets for the products to apply and the cleaning liquids to hand in case you
need to consult them.
13. Approvals
SPAIN - Approved by the Ministry of Industry and Energy with the numbers AP 1070 FBZ 2330.
FRANCE - Constructed according to CODAP standard, and in accordance with the Ministerial Orders
dated 18/01/43 and 24/03/78.
GREAT BRITAIN - Constructed according to standards BRITISH STANDARD 1101-1977.
GERMANY - Constructed according to standards A.D. MERKBLÄTTER.
www.elcometer.com
EN 13