Non-Fader Output Settings (Output); Loudness Settings (Loudness); Speaker Layout Settings (Sp Layout); Importing Sound Data (Sound Data) - Eclipse CD7000 Manual Del Propietário

Non-Fader Output settings (Output)

Press the [SELECT] (Lower) button
1
to select the Output.
The selected item is highlighted.
Press the [SELECT] (Right/Left)
2
button to select
Monaural.
Right: Monaural
Left: Stereo
Press the [CUSTOM] or [RTN]
3
button to exit sound adjustment
mode.

Loudness settings (Loudness)

The loudness control may be turned on to
emphasize low and high frequencies at low
volume levels. Loudness compensates for the
apparent weakness of low and high frequencies
at low volume by boosting the bass and treble
levels.
Press the [SELECT] (Upper/ Lower)
1
button to select the Loudness.
The selected item is highlighted.
2
Press the [ENTER] button.
The loudness
activated.
Press the [SELECT] (Upper/ Lower)
3
button to select ON or OFF.
ATTENTION
Loudness control is not available when CSII is
ON. In order to enable loudness control, turn
OFF CSII. (For details on turning CSII ON/
OFF, see page 68.)
Press the [CUSTOM] or [RTN]
4
button to exit sound adjustment
mode.
How to operate the Sound Adjustment Mode
Stereo or
setting mode is
Speaker layout settings (SP
Layout)
Depending upon speaker layout, you can switch
between 3-way and 4-speaker systems. (Select a
system configuration before adjusting PEQ, time
alignment or cross over.)
Press the [SELECT] (Upper/ Lower)
1
button to select the SP Layout.
2
Press the [ENTER] button.
The time speaker layout setting mode
is activated.
Press the [SELECT] (Upper/ Lower)
3
button to select 3 WAY or 4 SP+SW.
The selected item is highlighted.
Press the [ENTER] button for more
4
than five seconds.
"OK?" message will appear.
Press the [ENTER] button for less
5
than one second.
Press the [CUSTOM] or [RTN]
6
button to exit sound adjustment
mode.
CAUTION
When switching between 3 WAY and 4
SP+SW mode, please make sure that
the volume level is set to 0.
Importing Sound Data (Sound
Data)
Sound data adjusted by the E-iSERV website
can be downloaded to a CD-R or a memory stick
and imported into the main unit.
Press the [SELECT] (Upper/ Lower)
1
button to select the Sound Data.
2
Press the [ENTER] button.
The sound data importing mode is
activated.
XII
75