Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Note: Some models are pro-assembled. Assembly
is not needed on these models. See Saw Chat;7Te;>
sic;7Adjustme;Tt.
_h WARNING: Cutting
edges on chain
are sharp. Use protective gloves when
handling
chain.
IMPORTANT:
Do not clamp chain
saw in
vise during
assemNy.
1. Lay chain out fiat.
2.
Loosen and remove guide bar nuts and sprocket
cover.
3.
Loosen
and remove drive sprocket
screw or re-
move E-ring from shaft (see Figure 4). Remove
sprocket support.
4.
Install guide bar onto saw body. Assemble
center
slot of guide bar onto guide bar bolts.
5.
To replace sprocket support, repeat step 3 in re-
verse order. Firmly tighten drive sprocket screw
with #2 Phillips
screwdriver
(if applicable).
6.
Place chain
around
drive
sprocket,
along
top
groove of guide bar, and around guide bar nose.
Note:
Make sure cutting edges of chain are fac-
ing in right direction.
Position chain so cutting
edges on top of guide bar face guide bar nose (see
Figure 4, and indicator on side cover of saw).
411 CAUTION:
Do not place chain on saw
backwards,
if chain
is backwards,
saw
will vibrate
badly
and will not cut.
7.
Insert tab of sprocket cover into sk)t on side cover
and rotate sprocket cover onto guide bar bolts
/
until sprocket cover rests against guide bar.
8.
Place guide
bar nuts, removed
in step 2, over
guide bar bolts.
IMPORTANT."
Tighten guide bar nuts finger tight
only.
9.
Turning
chain tensioning
knob (Model
RMI635W)
or chain
tensioning
screw
(Model
RMI632A),
adjust position
of adjust-
ment block until it is aligned and inserted into the
round adjusting hole on guide bar (see Figure 4,
5and 6). Turning chain tensioning
knob or chain
tensioning
screw counterclockwise
will move
adjustment
block to rear of guide bar. Turning
chain tensioning
knob or chain tensioning
screw
clockwise
will move adjustment
block to front
of guide bar.
10. If needed, leadjust guide b_u nuts to finger tight only.
l l. Adjust saw chain tension.
Follow
steps under
Saw Chair7 TetTsiot7 AdjustmetTt.
Drive Sprocket
Sprocket
Support
Drive Sprocket
Screw or E-R{ng
\\
,
Sprocket
Cover
Guide Bar Nuts
I Adjusting
Hole
Bar Bolts
- Guide Bar
Saw Chain
Towards Guide Bar Nose
/
/
Chain
Tensioning
Screw
Cutting Edge
Figure 4 - Assembling
Guide Bar and Chain
Adjustment
Adjustment
Block
E-Ring
Block
Figure
5 - Turn Chain
Tensioning
Screw
on
Model RM1632A
Chain Tensioning
Knob
/
Figure 6- Turn Chain Tensioning
Knob on Model
RM1635W
Publicidad
