LG LMXS27626 Serie Manual De Instrucciones página 13

INSTALLATION 13
Removing/Assembling 1"he
Freezer Drawer Handle
Removing fhe Handles
1
Loosen the set screws D located on the
lower side of the handle with a _/8in. Alien
wrench and remove the handle.
Loosen the mounting fasteners _ that
connect to the freezer drawer and handle
using a V4in. Alien wrench, and remove
the mounting fasteners.
Assembling fhe Handles
1
Assemble the mounting fasteners D at
both ends of the handle using a 1/4in, Allen
wrench.
Place the handle on the door by fitting
the handle footprints over the mounting
fasteners and tightening the set screws
with a 1/sin. Allen wrench.
Removing/Assembling fhe
Doors and Drawers
Removing the doors is always recommended
when it is necessary to move the refrigerator
through a narrow opening,
FZ_ WARNING
• If your entrance door is too narrow for the
refrigerator to pass through, remove the
refrigerator doors and move the refrigerator
sideways through the doorway.
• Use two or more people to remove and
install the refrigerator doors. Failure to do
so can result in back or other injury.
o Disconnect the electrical supply to the
refrigerator before installing. Failure to do
so could result in serious injury or death.
Do not put hands, feet or other objects into
the air vents or bottom of the refrigerator.
You may be injured or receive an electrical
shock.
, Be careful when handling the hinge and
stopper. It may result in injury,
Remove food and bins from the doors and
drawers before detaching.
\
Removing fhe Left Refrigerafor Door
The water supply is connected to the
upper right part of the rear surface of the
refrigerator, Remove the ring in the joint
area, Hold the water supply connection
and gently push the Collet to detach the
water supply line as shown in O and _.
r_
NOTE -'I
Detachment ofthewater supplyline is
applicableonlywhen detaching the left