24
HOW
TO USE
HOW TO USE
Clean
the
refrigerator.
Clean your refrigerator thoroughly and wipe off all dust that accumulated during
shipping.
]_z_
CAUTION
I'
Do not scratch the refrigerator with a sharp object or use a detergent that
contains alcohol, a flammable liquid or an abrasive when removing any tape
or adhesive from the refrigerator,.
I"
Do not peel off the model or serial number label or the technical information
t
on the rear surface of the refrigerator.
Remove adhesive residue by wiping it off with your thumb or dish detergent.
Connect
the power
supply.
Check if the power supply is connected before use.
Read the "Turning On The Power" section.
Turn
off the icemaker
if the refrigerator
is not yet connected
to the
water
supply.
Turn off the automatic icemaker and then plug the power plug of the refrigerator
into the grounded electric outlet.
* This is applicable only to certain models.
{_
CAUTION
}
unning the automatic
icemaker before connecting it to the water
supply may cause the refrigerator
to malfunction,
Waif
for the refrigerator
to cool.
Allow your refrigerator to run for at least two to three hours before putting food in
it. Check the flow of cold air in the freezer compartment to ensure proper cooling.
-_
CAUTION
1
utting food in the refrigerator
before it has cooled could cause the
food to spoil, or a bad odor could remain inside the refrigerator.
The
refrigerator
makes
a Joud noise
after
initial
operation.
This is normal. The loudness will decrease as the temperature lowers.
Open
refrigerator
doors
and freezer
drawers
to ventilate
the inferior.
The inside of the refrigerator may smell like plastic at first. Remove any adhesive
tape from inside the refrigerator and open the refrigerator doors and the freezer
drawers for ventilation.