Descargar Imprimir esta página
Broan HLB9 Manual De Instrucciones
Broan HLB9 Manual De Instrucciones

Broan HLB9 Manual De Instrucciones

Ventiladores para montaje en línea
Ocultar thumbs Ver también para HLB9:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

LS
L
&
LB11
E
LOWE
For use with Broan Elite and NuTone Premier Hoods.
Page 1
FOR DOMESTIC COOKING ONLY
WARNING
WARNING
TO REDUCETHE RISK OF FIRE, ELECTRIC SHOCK, OR iNJURY
TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If
you have questions, contact the manufacturer at the address or
telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service panel
and lock the service disconnecting means to prevent power from
being switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to pre-
vent backdrafting. Follow the heating equipment manufacturer's
guideline and safety standards such as those published by the
National Fire Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
5. When cutting or drilling into wall or ceiling, do not damage electri-
cal wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. To reduce the risk of fire, use only metal ductwork.
8. Ifthis unit is to be installed over a tub or shower, it must be marked
as appropriate for the application and be connected to a GFCI
(Ground Fault Interrupter) - protected branch circuit.
9. Never place a switch where it can be reached from a tub or
shower.
10.This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Never leave surface units unattended at high settings. Boilovers
cause smoking and greasy spillovers that may ignite. Heat oils
slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when flambe-
ing food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef
Flambe').
3. Clean ventilating fans frequently. Grease should not be allowed
to accumulate on fan or filter.
4. Use proper pan size. Always use cookware appropriate for the
size of the surface element.
TO REDUCETHE RiSK OF INJURYTO PERSONS INTHE EVENT
OFA RANGETOP GREASE FIRE, OBSERVETHE FOLLOWING:*
1. SMOTHER
FLAMES with a close-fitting
lid, cookie sheet, or
metal tray, then turn off the burner. BE CAREFULTO
PREVENT
BURNS. If the flames do not go out immediately, EVACUATE AND
CALL THE FIRE DEPARTMENT.
2. NEVER PICK UPA FLAMING PAN -You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels - violent
steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher and you already
know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department
is being called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Fire Safety Tips" published by NFPA.
CAUTION
1. For general ventilating use only. Do not use to exhaust hazardous
or explosive materials and vapors.
2. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction
dust, etc. off power
unit.
3. If ventilator
is installed in an unconditioned
space (such
as an attic): Surround the ventilator with thermal insulation - to
minimize possible condensation.
4. Please read specification label on product for further information
and requirements.
TABLE OF CONTENTS
This manual is divided into sections as follows:
• "TYPICAL
INSTALLATION"
This section shows a common installation.
- Mounting (New Frame Construction)
- Mounting (Existing Frame Construction)
- Mounting Using Hanger Kit (included)
- Ducting (Horizontal blower discharge)
- Wiring
• "MOUNTING
OPTIONS"
• "WIRING PLATE POSITION"
• "DUCTING
OPTIONS"
- Blower Discharge Positions
- Ducting (Vertical blower discharge)
• "USE AND CARE"
• "SERVICE PARTS"
• "WARRANTY"
installer:
Leave this manual with
the homeowner.
Homeowner:
Use and Care
information on page 4.

Publicidad

loading

Este manual también es adecuado para:

Hlb11