Step By Step Instructions; Installing Your Dryer; Step 1 - Unpack The Dryer; Step 2 - Attach A Power Cord To The Dryer (Electric Dryer Only) - Haier HLTD500AEW Manual Para El Usuario

STEP BY STEP INSTRUCTIONS

INSTALLING YOUR DRYER

We recommend that your new dryer be installed by a quali ed appliance technician.
If you feel that you have the skills to install the dryer, please read the installation
instructions thoroughly before installing.
CAUTION: If, after completing these steps, you are unsure that the dryer is properly
installed, contact a quali ed appliance technician.

STEP 1 - UNPACK THE DRYER

1. Remove all packing materials. This includes the foam base and all adhesive tape
holding the dryer accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
using the dryer.



STEP 2 - ATTACH A POWER CORD TO THE DRYER
(ELECTRIC DRYER - U.S. ONLY)
1. Remove the screw securing the terminal block access cover, located on the back
of the dryer’s upper corner.
Terminal Block Access Cover
Hole in Strain Relief Mounting
Bracket
Access Cover Screw
2. Insert a UL listed strain relief into the mounting bracket hole. Position the strain
relief so that one tab is pointing up and one tab is pointing down. Tighten the
strain relief screws just enough to hold the two halves together.
16



