Step 2 - Connect To A Gas Supply Line (Gas Dryer Only) - Haier HLTD500AEW Manual Para El Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 2 - CONNECT TO A GAS SUPPLY LINE
(GAS DRYER ONLY)
NOTE: Do not connect the dryer to an LP gas line without rst converting the
dryer with a conversion kit. An LP conversion kit must be installed by a quali ed
technician.
NOTE: Apply a pipe-joint compound that that is resistant to the action of LP gas to
all males threads. Do not use plumber’s tape.
1. Turn the gas supply o by moving the shuto valve to the closed position.
Closed Valve
Open Valve
2. Disconnect and discard old exible gas connector. Replace with a new CSA(AGA)
approved exible gas connector.
3. Remove the shipping cap from the gas inlet pipe at the rear of the dryer.
4. Connect a
" NPT elbow to the gas inlet pipe on the dryer. Then connect a are
adapter to the elbow.
IMPORTANT: Use a pipe wrench to keep the dryer gas inlet pipe from twisting.
Gas Inlet Pipe on
the Dryer
" NPT Elbow
" NPT Flare Adapter
5. Connect the dryer to the gas supply line with a exible gas connector.
Flexible Gas Connector
6. Tighten the exible gas connector using two adjustable wrenches.
19

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Hltd500agwHltd500acw

Tabla de contenido