Kohler Stillness K-31404-PF-HW1 Instrucciones De Instalación página 2

Thank You for Choosing KOHLER
Need help? Contact our Customer Care Center.
• USA/Canada: 1-800-4KOHLER (1-800-456-4537) Mexico: 001-800-456-4537
• Service parts: kohler.com/serviceparts
• Care and cleaning: kohler.com/clean
• Patents: kohlercompany.com/patents
Important Information
WARNING: Risk of electric shock. Connect only to a properly-grounded dedicated circuit protected by a Class A
Ground-Fault Circuit-Interrupter (GFCI)*. Use 120 V, 60 Hz, 15 A service.
WARNING: Risk of electrical shock. To reduce the risk of electrical shock, route the 120 V power cord of the bath
through a conduit separately from the solenoid and valve wiring conduits.
WARNING: Risk of electric shock. Disconnect the power before servicing.
CAUTION: Risk of personal injury. This bath is extremely heavy. Obtain sufficient help and use lifting straps to lift
or move the bath.
NOTICE: Grounding is required. The unit should be installed and grounded by a qualified service representative.
The bath must be connected only to a supply circuit that is protected by a Ground-Fault Circuit-Interrupter (GFCI)*. Such
a GFCI should be provided by the installer and should be tested on a routine basis. To test the GFCI, press the test button.
The GFCI should interrupt power. Press the reset button. Power should be restored. If the GFCI fails to operate in this
manner, the GFCI is defective. If the GFCI interrupts power to the bath without the test button being pressed, a ground
current is flowing, indicating the possibility of an electric shock. Do not use this bath. Disconnect the bath and have the
problem corrected by a qualified service representative before using.
An equipment grounding terminal is provided in the field wiring compartment. To reduce the risk of electrical shock, this
terminal must be connected to the grounding means provided in the electrical supply panel with a conductor equivalent
in size to the circuit conductors supplying this equipment.
Install this unit in accordance with the Canadian Electric code, Part I.
*Outside North America, this may be known as a Residual Current Device (RCD).
Follow all local plumbing, building, and electrical codes.
To ensure a successful installation, install the bath on a level finished floor.
Provide access to plumbing and electrical connections around the bath for future maintenance.
This bath conforms to IAPMO Z124. All dimensions are nominal.
1485077-2-A
2 Kohler Co.