Kohler Stillness K-31404-PF-HW1 Instrucciones De Instalación página 4

1. Prepare the Site
Drain
WARNING: Risk of electrical shock. To reduce the risk of electrical shock, route the 120 V power cord of the bath
through a conduit separately from the solenoid and valve wiring conduits.
NOTICE: Measure your product for site preparation. Note the model number on the packaging label, then visit the
product page at kohler.com
IMPORTANT! Verify that the subfloor is flat and level. This will help minimize the leveling adjustments necessary for
proper product performance.
NOTE: The controller is mounted to the underside of the bath shroud. If desired, the controller may be relocated near the
digital valve to allow easier access if service is needed.
NOTE: Provide service access to the vacuum breakers. Device can spill water. Install where spillage is not objectionable.
Refer to the manufacturer's installation guide for the vacuum breaker.
1485077-2-A
Template
Electrical Conduit
Bath Inlet
6'' (152 mm)
46'' (1168 mm)
for more information.
Electrical Outlet
4
Digital Valve
Controller Cable
Water Inlets
ASSE 1001
Vacuum Breaker
Water Supply Tubing
Controller Power
Electrical Conduit
Kohler Co.