Publicidad
Idiomas disponibles
Idiomas disponibles
iNSTALLATiON
STEP
5
Hang
the
Opener
Three representative
installations are shown. Yours may
be different. Hanging brackets should be angled
(Figure 1) to provide rigid support. On finished ceilings
(Figure 2 and Figure 3), attach a sturdy metal bracket to
structural supports before installing the opener. This
bracket and fastening hardware are not provided.
1. Measure the distance from each side of the motor unit
to the structural support.
2. Cut both pieces of the hanging bracket to required
lengths.
3. Drill 3/16" pilot holes in the structural supports.
4. Attach one end of each bracket to a support with
5/16"-9xl-5/8"
lag screws.
5. Fasten the opener to the hanging brackets with
5/16"-18x7/8" hex bolts, lock washers and nuts.
6. Check to make sure the rail is centered over the door
(or in line with the header bracket if the bracket is not
centered above the door).
7. Remove the 2x4. Operate the door manually. If the
door hits the rail, raise the header bracket.
NOTE: DO NOT connect power to opener at this time.
HARDWARE
SHOWN ACTUAL
SIZE
Lag Screw 5/16" 9xl 5/8"
D
D%
Hex Bolt
5/16"-18x7/8"
Nut 5/16"-18
Lock Washer 5/16"
To avoid possible SERIOUSINJURYfrom a falling garage
door opener, fasten it SECURELY to structural supports of
the garage. Concreteanchors MUST be used if installing any
brackets into masonry.
Figure 1
Suppo_s
Measure
',
Distance
Bolt 5/16"-18x7/8"
Lock Washer 5/16"
Nut 5/16"-18
Lag Screw
5/16"-9xl-5/8"
Figure 2
Bracket
(NotProvided)
Bolt 5/16"-18x7/8"
Lock Washer 5/16"
Nut 5/16"-18
Hidden
_
J
Support
._-'-
Lag Screw
5/16"-9xl-5/8"
(Not Provided)
5/16"-18x7/8"
Lock Washer 5/16"
Nut 5/16"-18
Figure 3
Bolt 5/16"-18x7/8"
LockWasher5/16"
Nut 5/16"-18
(Not Provided)
Lock Washer 5/16"
Nut 5/16"-18
16
Publicidad
