Publicidad
Idiomas disponibles
Idiomas disponibles
Using
the
Wall-Mounted
Door
Control
To Open
the
Door
Manually
THE PREMIUM CONTROL CONSOLE
Press the lighted push button to open
Lighted
Push Button
or close the door. Press again to
reverse the door during the closing
cycle or to stop the door while it's
Light
opening.
Button
Light feature
Lock
Button
Press the Light button to turn the
opener light on or off. It will not control
the opener lights when the door is in motion. If you turn it
on and then activate the opener, the light will remain on
for 4-1/2 minutes. Press again to turn it off sooner. The
4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or
3-1/2 minutes as follows: Press and hold the Lock button
until the light blinks (about 10 seconds). A single blink
indicates that the timer is reset to 1-1/2 minutes. Repeat
the procedure and the light will blink twice, resetting the
timer to 2-1/2 minutes. Repeat again for a 3-1/2 minute
interval, etc., up to a maximum of four blinks and 4-1/2
minutes.
Lock feature
Designed to prevent operation of the door from
hand-held remote controls. However, the door will open
and close from the Door Control, the Outdoor Key Switch
and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push button light will flash as long as the
Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push button light will stop flashing. The
Lock feature will also turn off whenever the "learn" button
on the motor unit panel is activated.
Additional
feature when used with the 3-Function
hand-held
remote
To control the opener lights:
In addition to operating the door, you
may program the remote to operate the
lights.
1. With the door closed, press and hold
a small remote button that you want to control the light.
2. Press and hold the Light button on the door control.
3. While holding the Light button, press and hold the Lock
button on the door control.
4. After the opener lights flash, release all buttons.
To prevent possible SERIOUSINJURYor DEATHfrom a
falling garage door:
•
If possible, use emergency releasehandle to disengage
trolley ONLYwhen garage door is CLOSED.Weak or
broken springs or unbalanceddoor could result in an open
door falling rapidly and/or unexpectedly.
•
NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
•
NEVERuse handle to pull door open or closed. If rope
knot becomes untied, you could fall.
DISCONNECT
THE TROLLEY:
The door should be fully closed
if possible. Pull down on the
emergency release handle (so
that the trolley release arm
snaps into a vertical position)
and lift the door manually. The
lockout feature prevents the
trolley from reconnecting
automatically, and the door can
be raised and lowered
manually as often as
necessary.
Trolley
I
Rele_
__*_
(In Manual
Disconnect
Position)
Lockout position
(Manual disconnect)
TO RE=CONNECT THE TROLLEY:
Pull the emergency release
handle toward the opener at
an angle so that the trolley
release arm is horizontal. The
trolley will reconnect on the
next UP or DOWN operation,
either manually or by using
the door control or remote.
Trolley
Emergency
Release Handle
(Down and Back)
To reconnect
31
Publicidad
