Concept PN3000 Manual Del Usuario página 34

EN
CONTROL AND CHARGING
Lower speed - switch on the machine by pressing and
holding the button for 3 seconds, the machine will start
working at a lower speed.
More speed - Change speed at the touch of a button.
Off - Press and hold the button for 3 seconds.
Charging - If the device has not been used for a long
time or is being charged for the first time, charge it
continuously for at least 2 hours.
Always charge your device between 2.5 hours and 12
hours. Charge and store between +5 and 35 degrees
Celsius.
1. Switch off the device.
2. Insert the charging cable into the charging port.
When the device is charging, the indicator lamp lights
up/displays the numbers up to 100% charge (Figure 2).
Fully charged - the indicator light comes on.
GRINDING HEAD REPLACEMENT
For hygiene reasons, it is recommended that each quartz
disc is used by one person only, preferably not with
others.
1. Hold the product with one hand and remove the
grinding head with the other.
2. When replacing the abrasive head, install the new
abrasive head, you will hear a "click" sound to make
sure the newly installed abrasive head is in place. If the
abrasive head is not inserted correctly, do not start the
machine.
66
CLEANING AND MAINTENANCE
1. First remove the head cap, then remove the grinding
head and dust cap.
2. Use a cleaning brush to remove leather debris and
dust. Do not handle the appliance while cleaning. v
The grinding head and body can be rinsed with water.
NOTE: Do not use salt water, water above 60 degrees
Celsius, solvents, petrol, alcohol or other chemicals for
cleaning.
SERVICE CENTRE
Extensive maintenance or repair, which requires access
to internal parts of the product, has to be performed by
a qualified service centre.
ENVIRONMENTAL CONCERNS
• Packaging materials and old appliances should be
recycled.
• Packaging materials may be disposed of as sorted
waste.
• Dispose the plastic bags made of polyethylene (PE) of
as sorted waste.
EN
67