Publicidad
Idiomas disponibles
Idiomas disponibles
4. PLACEMENT OF THE BATTERY
The Call Point software allows you to create message schedules and volume schedules, and to send these schedules to the equipment.
In this way, it is not necessary to use a server PC to activate the time schedules, but the equipment activates them automatically.
For this purpose, the unit incorporates a RTC (Real-Time Clock) whose function is to maintain the current time. To keep the RTC
powered even if the equipment is turned off, a 3V lithium battery type CR2032 supplied with the equipment must be used.
It is recommended to replace the battery at least every 5 years.
Handling batteries properly:
• Warning! Improper use of battery may lead to explosion. Replace the batteries with the same or equivalent type only.
• Batteries may endanger life if swallowed. If a battery is swallowed, seek medical assistance immediately.
• Before inserting the batteries, check whether the contacts in the device and batteries are clean and, if necessary, clean them.
• Only use new batteries.
• Do not use rechargeable batteries
• Never try to recharge normal batteries. There is a risk of explosion!
• Never expose batteries to heat sources (e.g. radiators) or direct sunlight. There is an increased risk of leakage!
• Never short-circuit the batteries.
• Never throw batteries into a fire.
• Do not disassemble or deform batteries.
• If the equipment is not going to be used for long periods, remove the battery.
• Remove leaking batteries from the device immediately. If battery acid leaks out it is essential to avoid contact with the skin,
eyes and mucous membranes! If the acid does come into contact with skin, immediately rinse the affected areas with plenty
of clear water and consult a doctor immediately. There is a risk of acid poisoning and acid burns!
• Remove exhausted rechargeable battery from the device immediately! There is an increased risk of leakage
• Do not throw used batteries into the household waste. The batteries must be deposited in a collection point for used batteries.
Battery placement procedure:
1)
Disconnect the power strips (POWER
SUPPLY 1 and POWER SUPPLY 2).
COMPACT version 5.2.002 ENG
COMPACT
4ETH
Figure 12
Modular audio matrix
with IP connection
R + D Department
10
Publicidad
